CNCGLASS-Product-Catalog-Peel-Ply-for-Vacuum-Infusion

This catalog describes CNCGLASS peel ply for vacuum infusion, a clean release fabric placed against the laminate while the part is under vacuum. After the resin has cured, the cloth peels away and leaves a uniformly textured face that is ready for secondary bonding, coating, or further assembly. The range is woven from high-strength PA66, PA6, or PET yarns so the fabric can be matched to the process temperature and the resin system in use. Every roll is thoroughly rinsed and heat-set, so the cloth stays free of surface contamination and the peeled laminate develops a consistent roughness. Typical uses include vacuum processing of wind-turbine blades, marine structures, and aerospace composite parts. The catalog lists PA66 grades at 85 and 105 g/m² rated to 230 °C for pultrusion and prepreg molding, PA6 grades at 85 and 105 g/m² rated to 210 °C for vacuum processing, and PET grades at 85 and 105 g/m² rated to 180 °C, along with product photographs, a process schematic, and contact details. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.

CNCGLASS-Product-Catalog-Peel-Ply-for-Pultrusion

This catalog describes CNCGLASS peel ply for pultrusion, a high-strength PA66 release fabric made for continuous pultrusion lines. The cloth is intended to run at elevated temperature and to leave a clean, consistent interface on pultruded glass plate, helping the resin bond develop higher shear strength. A dedicated PA66 high-strength yarn gives the fabric its heat resistance and mechanical strength, and the edges are heat-sealed so the cut end stays flat, without loose filaments or a ruffled selvage. The catalog lists PA66 grades at 85 and 105 g/m² with a maximum recommended use temperature of 230 °C for pultrusion and prepreg molding, PA6 grades at 85 and 105 g/m² rated to 210 °C for vacuum processing, and PET grades at 85 and 105 g/m² rated to 180 °C, along with product photographs and contact details. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.