CNCGLASS-Ionoplast-Interlayer-Laminating-Process-Guide

This processing guide gives glass fabricators recommended starting practice for laminating architectural and structural glazing with the CNCGLASS ionoplast interlayer, a stiff ionic-type film intended for high structural performance and reliable post-breakage retention. Conventional PVB laminating equipment can generally be used; the temperatures, pressures and times in the note are starting points that should be validated and fine-tuned on each production line.

The note covers packaging and storage of foil-bagged rolls (use within two years of production; material above 0.2% moisture should not be used; recommended lay-up conditions are 22–28 °C and 18–28% RH), cutting and trimming without sawing, cleaning, and glass preparation with the interlayer laid against the tin sides in the ATTA orientation. It then describes nip-roll pre-pressing and vacuum-bag de-airing, followed by an autoclave hold of 132–135 °C at 180–200 psi for at least 60 minutes and a cooling rate of at least 3 °C/min. Further sections address multi-ply stacks, when an adhesion promoter is required, coated and fritted glass, daily quality checks, and a troubleshooting table for low adhesion, trapped air, rainbow distortion and high haze.

The document is a CNCGLASS technical note and processing guide. It is not a third-party test certificate or a certificate of conformity, and it does not authorise the use of any third-party laboratory mark. This technical note does not list prices. Enquiries can be sent to cnc@cncglass.com. The full guide is in the PDF below.

Published by

cnc@cncGlass.com EVA film glass interlayer

Peter Lin Mail: cnc@cncGlass.com cnc@cncEva.com Whatsapp: 0086 15013829504 Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant