CNCGLASS-Thermal-Cutter-CNC02-CNC01-and-Heavy-Duty-Pro250

This catalog presents the CNCGLASS Thermal Cutter range used to clean overflowed interlayer remains from laminated glass edges after heating in the oven. The tool trims the remains by heat rather than by force or sharpness, and is described for use with EVA, SGP, and other interlayers.

CNC02 is designed for continuous operation with an air-cooling system and has 16 adjustable temperature settings, so the blade does not have to be taken to its highest setting on every job. It is described as lighter and easier to hold than CNC01, and as able to trim edges with minimal smoke and no burned marks. CNC01 is intended for intermittent operation: the button should be released after short heating periods so the blade does not overheat. Plug options listed are CE standard AC 230 V / 50 Hz and US standard AC 120 V / 60 Hz.

The Heavy Duty Heat Cutter Pro250 is intended for longer continuous cutting, about 10 hours. It uses a separated power supply, so the handheld unit weighs 250 g and stays cool at the handle. It has a stand-by temperature, with the blade pre-heated when the unit is turned on, and is listed as compatible with the popular blades for glass interlayer trimming: 3.2, 4.2, 11.2, 14.2, R blade, and F blade.

Blades are not interchangeable between the continuous and intermittent models. Blades 3.2, 4.2, 11.2, and 14.2 are for CNC02 and cannot be used in CNC01. Blades 3.1, 4.1, 11.1, and 14.1 are for CNC01 and cannot be used in CNC02. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.

Published by

cnc@cncGlass.com EVA film glass interlayer

Peter Lin Mail: cnc@cncGlass.com cnc@cncEva.com Whatsapp: 0086 15013829504 Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant