CNCGLASS-Vacuum-Process-Materials-Product-Summary

This product summary covers six CNCGLASS vacuum process materials used in oven curing, vacuum infusion, and related lamination work.

The multilayer polyester–nylon vacuum bagging film is intended for oven curing up to 160°C. Typical thicknesses are 50 μm, 65 μm, and 75 μm, with widths up to 12 m, in tube, sheet, or centerfold supply. The film is yellow. A synthetic-rubber vacuum bag sealant tape is rated for process use from room temperature up to 200°C, typically 3 mm × 12 mm × 15 m, in yellow, and is described as peeling from the mold after the cure cycle. A silicone-coated nylon peel ply is listed for vacuum infusion, hand lay-up, and prepreg stacks up to 204°C; typical values are about 62 g/m² and 0.11 mm thickness, with a standard roll about 1.52 m × 91 m, in blue.

A polyolefin release film is rated up to 158°C, typically about 40 μm thick and 1.5 m wide, in red, and is offered perforated or non-perforated. A nonwoven polyester breather felt of about 340 g/m² is listed for high-pressure vacuum bagging and prepreg work up to 204°C, with a typical roll about 1.52 m × 46 m, in white. A high-temperature polyester pressure-sensitive tape is rated up to 204°C for holding breather, release film, peel ply, and bag film during layup; typical widths are 25.4 mm and 50.8 mm × 66 m, in blue. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.

Published by

cnc@cncGlass.com EVA film glass interlayer

Peter Lin Mail: cnc@cncGlass.com cnc@cncEva.com Whatsapp: 0086 15013829504 Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant