CNCGLASS-Product-Catalog-Peel-Ply-for-Vacuum-Infusion

This catalog describes CNCGLASS peel ply for vacuum infusion, a clean release fabric placed against the laminate while the part is under vacuum. After the resin has cured, the cloth peels away and leaves a uniformly textured face that is ready for secondary bonding, coating, or further assembly. The range is woven from high-strength PA66, PA6, or PET yarns so the fabric can be matched to the process temperature and the resin system in use. Every roll is thoroughly rinsed and heat-set, so the cloth stays free of surface contamination and the peeled laminate develops a consistent roughness. Typical uses include vacuum processing of wind-turbine blades, marine structures, and aerospace composite parts. The catalog lists PA66 grades at 85 and 105 g/m² rated to 230 °C for pultrusion and prepreg molding, PA6 grades at 85 and 105 g/m² rated to 210 °C for vacuum processing, and PET grades at 85 and 105 g/m² rated to 180 °C, along with product photographs, a process schematic, and contact details. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.

Published by

cnc@cncGlass.com EVA film glass interlayer

Peter Lin Mail: cnc@cncGlass.com cnc@cncEva.com Whatsapp: 0086 15013829504 Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant