CNCGLASS-Product-Catalog-Peel-Ply-for-Pultrusion

This catalog describes CNCGLASS peel ply for pultrusion, a high-strength PA66 release fabric made for continuous pultrusion lines. The cloth is intended to run at elevated temperature and to leave a clean, consistent interface on pultruded glass plate, helping the resin bond develop higher shear strength. A dedicated PA66 high-strength yarn gives the fabric its heat resistance and mechanical strength, and the edges are heat-sealed so the cut end stays flat, without loose filaments or a ruffled selvage. The catalog lists PA66 grades at 85 and 105 g/m² with a maximum recommended use temperature of 230 °C for pultrusion and prepreg molding, PA6 grades at 85 and 105 g/m² rated to 210 °C for vacuum processing, and PET grades at 85 and 105 g/m² rated to 180 °C, along with product photographs and contact details. This catalog does not list prices. Enquiries can be sent to cnc@cncglass.com. The full catalog is in the PDF below.

Published by

cnc@cncGlass.com EVA film glass interlayer

Peter Lin Mail: cnc@cncGlass.com cnc@cncEva.com Whatsapp: 0086 15013829504 Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant