CNCGLASS EVA film & SGP interlayer

Written by Peter Lin
In some situation, laminated glass to be heated at low temperature is required, for example, if you want to laminate with some silk, PC film, PDLC switchable film, you may want to laminate at low tempeature below 100 C degreees.

Our EVAFORCE LOW TEMP 80-120 Interlayer film, is available for being laminated at 120C degrees or 80 C degreees.
When you select the low temperature laminating mode, the recipe seting of time and temperature is a big factor deciding if the result of laminated glass is succeeded or not.

Here is a test report from our client for your referece, but please note that, different laminating oven, different glass thickness and types, different room temperature in different regions, and different inserts of laminated glass may influence the recipe.

Hi Peter,
Our configuration wish is based on laminate glass thickness of 1.6 mm at 2 stage of temperature.

I finished some test of lamination Glass with Evaforce Low-temp 80-120 and there some results and comments;

1- Set up: 1st stage – 60 degrees 10 mins rump up and 20 mins soak time, 2nd stage 80 degree 10 mins rump up and 70 mins, results are not good the film looks like doesn’t melt correctly on some spots.

2- Set up: 1st stage – 65 degrees 10 mins rump up and 20 mins soak time, 2nd stage 80 degree 10 mins rump up and 100 mins, results are better, but still some spot looks like the film doesn’t melt correctly on some spots.

3- Set up: 1st stage – 65 degrees 10 mins rump up and 20 mins soak time, 2nd stage 82 degree 10 mins rump up and 190 mins, results are good. I’ll appreciate your comments and suggestion thanks.

—————
If you want to order too, please contact Peter Lin
Mail: [email protected]
Whatsapp: 0086 15013829504

EVAFORCE® SUPER CLEAR INTERLAYER FILM:for making architectural safety laminated glass

Super clear eva glass interlayer film
Outdoor white eva interlayer film series
Green tape for laminating sealing vacuuming, heating resistant
Thermal cutter trimming laminated glass edges remains by heating
www.cncGlass.com
www.cncEva.com
www.cncnext.com

Green Tape Preventing Melted Eva Film Over Flowing Out of Laminated Glass Edges in the Oven

1-EVAFORCE SUPER+ (COMPATIBLE) EVA INTERLAYER FILM

*Lowest melt viscosity
*Best compatibility with all kinds of uneven rough surface inserts
*Massive lamination, Largest sold quantity
*Great performance with affordable price
*Aim for architectural safety laminated glass
*Applied both indoor and outdoor

EVAFORCE® SUPER CLEAR INTERLAYER FILM:for making architectural safety laminated glass

2-EVAFORCE EXTREME EVA INTERLAYER FILM

*Less overflowing during vacuuming heating
*Strengthened safety mechanical properties
*Recommended for extreme environments, safety tempered glazing or curved glass laminating
*Applied both indoor and outdoor
*Replacing PVB Film

EVAFORCE® SUPER CLEAR INTERLAYER FILM:for making architectural safety laminated glass

3-WHITE EVA GLASS INTERLAYER FILM

Milky White/White Opaque EVA Film 0% Visible Light Transmittance
Sandblasting White/White Translucent EVA Film 65% Visible Light Transmittance
Super Milky White/Super White Opaque EVA Film 0% Visible Light Transmittance